Readme-SystemUpdaterForSNAKE.html
System Updater for SNAKE 0.35.0
Contents
- Introduction
- Notes
- Known Bugs
- File List
- Next Steps
- Revision History
This package contains the System Updater for the following development hardware.
- New Nintendo 3DS development hardware (KTR)
- New Nintendo 3DS XL development hardware (RED)
- New Nintendo 2DS XL development hardware (JAN)
- IS-RAY-DEBUGGER (IS-SNAKE Devkit Prototype)
- IS-SNAKE Devkit
Operation on development hardware that is not listed is not guaranteed.
Please contact support@noa.com if you have any concerns or encounter bugs not listed in this document.
-
Firmware Versions Supporting the New Nintendo 2DS XL Development Hardware
You will need to use version 0.25.18 or later of the firmware when using the New Nintendo 2DS XL development hardware.
You cannot use versions of System Updater for SNAKE earlier than 0.25.18.
-
When using IS-RAY-DEBUGGER, you must use the gamma version, or the beta version with the gamma version controller.
When using this updater on IS-RAY-DEBUGGER, it will not run properly unless the device is the gamma version or the beta version with a gamma version controller.
-
Can only be used in environments with System Updater 0.22.32 or later.
Because of a security update, this updater can only be used with 0.22.32 or later environments.
-
HOME Menu set to start when changing markets
If you use the System Updater for one market on development hardware for a different market, the settings change so that the HOME Menu starts.
Because the system initialization is done at the same time as the import, the initial setup screen for the HOME Menu is the first thing that appears.
This change was made to prevent problems that occurred when forgetting to initialize the system after changing the market. Note this change when changing the market.
-
Version Displayed in System Settings
The version is not accurately applied to System Settings on the development hardware's HOME Menu. A fixed value of "Ver. 0.0.0-0J" is displayed instead.
(The version is accurately applied on retail hardware.)
Check the "Firmware Ver." shown on TestMenu or DevMenu screens for the actual version.
-
Make sure that test units are being charged when updating them
If power is lost during an update, that could break the test unit.
Also, other hardware could also malfunction if the power is turned off during an update. Please be careful.
There are currently no bugs when updating.
- SystemUpdaterForSNAKE/
- SystemUpdater_SNAKE-0_35_0-JP.csu
System Updater for the JP region (Japan).
- SystemUpdater_SNAKE-0_35_0-US.csu
System Updater for the US region (Americas).
- SystemUpdater_SNAKE-0_35_0-EU.csu
System Updater for the EU region (Europe and Australia).
- SystemUpdater_SNAKE-0_35_0-KR.csu
System Updater for the KR region (Korea).
- SystemUpdater_Manual.pdf
System Updater Operations Manual.
- ReleaseNotes/
Revision History
For more information about how to use System Updater, see the System Updater Operations Manual.
2022-08-30 version
- 0.35.0 (2022-08-30)
Added support for system version 11.16.0.
CONFIDENTIAL