1. Introduction

This package contains the System Updater for the following development hardware.

Note that it will not operate on development hardware that is not listed above.

2. Notes

Firmware Versions Supporting the New Nintendo 2DS XL Development Hardware

You will need to use version 0.25.18 or later of the firmware when using the New Nintendo 2DS XL development hardware.
You cannot use versions of SD System Updater for SNAKE earlier than 0.25.18.

HOME Menu set to start when changing markets

If you use the System Updater for one market on development hardware for a different market, the settings change so that the HOME Menu starts.
Because the system initialization is done at the same time as the import, the initial setup screen for the HOME Menu is the first thing that appears.
This change was made to prevent problems that occurred when forgetting to initialize the system after changing the market. Note this change when changing the market.

Version Displayed in System Settings

The version is not accurately applied to System Settings on the development hardware's HOME Menu. A fixed value of "Ver. 0.0.0-0J" is displayed instead.
(The version is accurately applied on retail hardware.)
Check the "Firmware Ver." shown on TestMenu or DevMenu screens for the actual version.

Make sure that test units are being charged when updating them

If power is lost during an update, that could break the test unit.
Also, other hardware could also malfunction if the power is turned off during an update. Please be careful.

There are currently no bugs when updating.

For more information about how to use System Updater, see the System Updater Operations Manual.

2022-08-30 version

CONFIDENTIAL